Non-stick is used to save fuel, not stick to food, and is easy to clean. Therefore, more and more people have eliminated traditional iron making and switched to non-stick. However, if you scratch the non-stick slag, it will cause toxic substances. Which layer of non-stick slag should you choose is safer and easier to use? Experts point out that the advantages and disadvantages of different layers are different, and it depends on what your needs are most concerned about.

Which kind of slurry layer is safer if it is not sticky?

The principle of non-stick is to coat the outer layer of the pellet. The Food and Drug Administration pointed out that there are three common pellet layers that are non-stick, including synthetic resins (such as polytetrafluoroethylene PTFE (polytetrafluoroethylene), ceramics (such as pine dioxide), pine metal, etc.

. PTFE material is a polymer material with stable cold, heat and chemical properties, with better non-stick properties;

. Ceramic mattresses are characterized by their high hardness, difficulty in scratching, but relatively poor performance;

. The advantages of pine metal layer are light and heat-guiding and fast.

Should I just scrape it a little? How to determine the degree of scratching of non-sticky

When using non-sticky slicing, the most important thing to pay attention to is that non-sticky slicing may cause toxic substances, and if there are scratches, it should not be used again. But many people may think that they just scrape a little and don’t use it? What is the degree of scraping?

The nurse of the Clinical Toxic Center of Changgeng Hospital of Linkou, Cheng Dunci, once interviewed that he could boil water with a non-stick pot, and then observe the bubbles in the water. Once the bubbles in the water are big and small, it means that there are scratches and severe injuries. At this time, you should change the pot. Never use

The non-stick pot is most afraid of scratches, so all kinds of behaviors that may cause scratches in the pot should be avoided. For example, of course, the steel lens cannot be made of iron, and silicon lens should be used. Foods with shells, such as crab shells, fish thorns, chicken bones, etc., should also be carefully cooked.

Hot urgent cleaning, it is not your lungs but your pills!

Cleaning without sticking is also very important. Remember to use sea cubes and never use cabbage or steel brushes. In addition, many people are afraid that the oil will become more sticky and difficult to wash when it gets cold. Therefore, they are used to take the hot pot and clean it immediately after using it. When he was interviewed by Linkou Chang Geng Clinical Toxics Center and doctor of the kidneys, Yang Zonghai, who was a director of the Linkou Chang Geng Clinical Toxics Center and previously, he pointed out that in fact, the one that causes heat-washing is not your lungs, but your gun! Whether it is an iron or stainless steel, or even a stainless steel or any material such as glass, ceramics, etc., the operation will reduce the life of the utensil, and the utensil is more likely to be damaged due to the large temperature difference and the material is easily damaged.

6 precautions when using non-stick bulb

1. When buying a bulb, you should first read the contents of the instructions and use them correctly according to the product instructions.

2. Before the first use and after each use, neutral cleaning agent should be used with soft sea cucumbers to clean and clean. It should never be cleaned with a vegetable cloth or a steel brush.

3. Do not stick to the pot and pay special attention to avoid high temperature and empty burning, do not use high heat, and only fry and not fry.

4. Choose tinsels with caution and do not use materials that are harder than tinsels. It is recommended to use silicone tinsels.

5. Be careful when cooking crab shells, chicken bones and other ingredients with hard shells.

6. If there are depressions, defects or layers of debris on the surface, it should be replaced.